Avaya 4600 - Manual (Page 15)

Configuration preparation
Issue 2 July 2006 15
Preparing the Avaya Security Gateway for the VPNremote Phone
VPNremote Phone users who login to the VPN through the Avaya security gateway must have
their user authentication configured on that security gateway. The user authentication
configuration allows VPN traffic to flow through the corporate firewalls to the security gateway.
VPN traffic is remote traffic that has traversed the VPN tunnel.
As a minimum, you must configure a user name and the password for each remote user. User
names can be up to 128 characters long and can contain any character except a comma (,).
Note that once you add a user name, you cannot change the name.
For additional information regarding configuring the security gateway for the VPNremote Phone,
see the Avaya Security Gateway Configuration Guide for VPNos 4.6.
Configuring VPNremote Phone system parameters on the devices
Table 1 lists the configurable system parameters for the supported devices. For more
information regarding system parameters, see Appendix C: System Parameters Customization .
Table 1: Supported devices system parameters
Supported Device System Parameter Values
Avaya Security Gateway Set the following values:
NVVPNCFGPROF(1)
NVCERTUNK(2)
NVIKECONFIGMODE(2)
Cisco VPN 3000 Series Concentrators Set the following values:
NVVPNCFGPROF(3)
NVVPNSVENDOR(2)
NVVPNAUTHTYPE(4)
NVIKEXCHGMODE(1)
NVIKEIDTYPE(11)
NVIKECONFIGMODE(1)
Cisco PIX 500 Series Security Appliances Set the following values:
NVVPNCFGPROF(3)
NVVPNSVENDOR(2)
NVVPNAUTHTYPE(4)
NVIKEXCHGMODE(1)
NVIKEIDTYPE(11)
NVIKECONFIGMODE(1)
1 of 2