LumaSense Technologies INNOVA 1303 - Manual (Page 53)

Chapter 4
________________________________________________________________________
_______________________________________________________________________
BE1085-14
1303 Multipoint Sampler and Doser LumaSense Technologies A/S
Page 53 of 60
4.2.2 Sampler System Jobs
These jobs control the 1303’s sampler system. Further information
about these jobs is given in section 3.5 .
Table 4.2 The interface jobs which control the 1303’s sampler system.
Job Header Data Effect on 1303
Open_Sampling_Valve Up to 6 sampling-
valve numbers. Opens the speci-
fied sampling
valves.
Connect_Sampling_Valve To_Monitor
To_Sampling_Pump
Routes the air-
sample either to
the Gas Monitor,
or via the sam-
pling pump to the
Waste Air Out-
let.
Sampling_Pump On
Off Starts/stops the
sampling pump.
4.2.3 Doser System Jobs
These jobs control the dosing function of the 1303. For further infor-
mation about the calibration of the doser system, refer to section 3.4 .
For further information about using the doser system, see section 3.6 .