Appendix, Hardwarereset, Hardware – LT Security IP85PW User Manual

Page 54: Hardware reset, Reset, 5. appendix appendix appendix appendix

- 54 -

5. Appendix

Appendix

5.1.

1. Hardware

Hardware

Hardware Reset

Reset

After updating the IP device, or when there are some problems that you can’t

solve via reboot, for example, you can’t get the IP address via the search tool,

please try to reset the IP device. After this reset, all the parameters will be back to

the factory default, the IP address will be back to default: 192.168.1.199. Then

please set the IP address again according to the chapter:

Please following the below to finish the reset:

�

Step 1 Cut off the power of IP device, all the indicate lamps are off.

�

Step 2 Press the “RST” button with a pin, don’t release.

�

Step 3 Connect the power to the IP Device, the “STATE” indicate lamp will

flicker. Hold on another 30 seconds.

�

Step 4 Release the pin. Now, you can access the IP device now. Reset

successfully,

NOTE: If the reset is successful, the IP address will turn back to the default: