LT Security LTD2516HE - Manual (Page 23)

Digital Video Recorder User Manual version 1.0
23
Fig 4-30 network configuration-sub stream
Step2: select fps, resolution, quality, encode and max bit rate
Step3: user can setup all channels with same parameters, tick off “all”, then to do relevant setup.
Step4: click “default” button to resort default setting; click “apply” button to save the setting; click “exit” button to exit current interface.
Definitions and descriptions of network stream:
Parameter Meaning
FPS Range from: 1-25
Resolution Support CIF and D1
Quality The quality of the clients’ image. The higher the value is, the clearer the record image. Six
options: lowest, lower, low, medium, higher and highest.
Encode VBR and CBR
Max bit rate Range from: 64 Kbps
、128 Kbps、256 Kbps、512 Kbps、768 Kbps、1Mbps、2 Mbps
4.7 User management configuration
Step1: enter into system configuration user management configuration; refer to Fig 4-31:
Fig 4-31 user management configuration
Step2: click Add button, a dialog box will pop-up as Fig 4-32:
Fig 4-32 add-general
① General: Input user name, password; select user type: normal and advance, input the MAC address of the PC; click OK button, this user will be
added into the user list box; click Exit button to exit the current interface.
Note: when the default value of binding PC MAC address is 0, the user is not bind with the specify computer; the, the user can log in DVR on
the binding computer after set the specific binding MAC address.
②
Authority:
Step1: enter into Add user authority; refer to Fig 4-33: