Using bios, Power mangement setup – Elitegroup ST945GM (V1.0) User Manual

Page 39

Using BIOS

Serial Port3/4 IRQ (IRQ11/IRQ10)
Use this item to assign IRQ to the serial port.

Press to return to the main menu setting page.

Power Mangement Setup

This page sets up some parameters for system power management operation.

ACPI Suspend Type (S3)

Use this item to define how your system suspends. In the default, S3 (STR), the suspend
mode is a suspend to RAM, i.e., the system shuts down with the exception of a refresh
current to the system memory.

Soft-Off by PWR-BTTN (Delay 4 Sec)

Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake Up
Alarms. This item lets you install a software power down that is controlled by the power
button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then you have to hold the power
button down for four seconds to cause a software power down.

PWRON After Powe- Fail (Power Off)

This item enables your computer to automatically restart or return to its last operating
status after power returns from a power failure.

Resume On LAN (Disabled)

This item allows users to enable or disable LAN activity to wake up the system from a power
saving mode.

Wake-Up by PME (Enabled)

This item allows users to enable or disable PCI activity to wake up the system from a power
saving mode.

Select the ACPI
State used for
System Suspend.

Help Item

Power Management Setup

ACPI Suspend Type

[S3]

Soft-off by PWR-BTTN

[Delay 4 Sec]

PWRON After PWR-Fail [Power Off]
Resume On LAN

[Disabled]

Wake-Up by PME [Enabled]
Power On by Ring [Disabled]
USB Device Wakeup from S3 [Disabled]

F2: Switch to next color

F9: Load Default Settings

mnlk

: Move

ESC: Exit F1: General Help

F10: Save

Enter : Select +/-/: Value

Resume On RTC Alarm

[Disabled]