Elitegroup MD210 (V1.0) - Manual (Page 28)

23
Installing the Motherboard
IR1/LED1~3
This concludes Chapter 2. The next chapter covers the BIOS.
LED1 (CARD READER LED)
The LED1 can be used to indicate CARD READER status. The LED keeps blinking
when the CARD READER is in Active state.
System Status LED
Active Blinking
LED3 (HDD LED)
The LED3 can be used to indicate HDD status. The LED keeps blinking when the
HDD is in Active state.
LED2 (LAN LED)
The LED2 can be used to indicate LAN status. The LED keeps blinking when the
LAN is in Active state.
System Status LED
Active Blinking
System Status LED
Active Blinking
IR1 (Infrared Receiver)
The IR1 can be used to receive remote control signal.
1 IR_RX
2 GND
3 VCC
Pin Signal Name