Elitegroup MD210 (V1.0) - Manual (Page 14)

9
Installing the Motherboard
Checking Jumper Settings
The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.
Jumper Settings
Jumper Type Description Setting (default)
CLR_CMOS1 3-pin CLEAR CMOS
1-2: NORMAL
2-3: CLEAR
1-2: ENABLE
2-3: DISABLE
3-pin MED1
Before clearing the
CMOS, make sure to turn
off the system.
CLR_CMOS1
1
1
MED1
ME Disable
To avoid the system instability after clearing CMOS1, we recommend
users to enter the main BIOS setting page to
“Load Default Settings”
and then “Save & Exit Setup”.