Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 42)

Initial configuration
3
38 Brocade Mobility 1240 Access Point Installation Guide
53-1002917-01
17. Set the following DHCP and Static IP Address/Subnet information for the WAN
interface:
• Use DHCP - Select the checkbox to enable an automatic network address
configuration using the Access Point’s DHCP server.
• Static IP Address/Subnet - Enter an IP Address/Subnet and gateway for the
Access Point's WAN interface. These are required fields
• The port connected to the WAN - Select the port used as the physical
Access Point connection to the external network. The ports available differ
depending on the Access Point model deployed. Access Point models with
a single port have this option fixed.
• Enable NAT on the WAN Interface - Select the checkbox to allow traffic to
pass between the Access Point's WAN and LAN interfaces.
18. Select Next. The Initial AP Setup Wizard displays the Radio Configuration
screen to define support for the 2.4GHz radio band, 5GHz radio band or to set
the radio's functionality as a dedicated sensor.
NOTE
The ADSP Sensor Server field displays at the bottom of the screen only if a
radio has been dedicated as a sensor.