Brocade Mobility 1240 Access Point Installation Guide User Manual
Page 17

Wall mount instructions
2
Brocade Mobility 1240 Access Point Installation Guide
13
53-1002917-01
e. Attach the power supply line cord to a power supply.
7. Attach supported 2.4 GHz or 5 GHz antennas to the connectors. For more
information on supported Mobility 1240 Access Point antennas, see
1240 Access Point antenna options” on page 20.
8. Verify the access point is receiving power by observing the LEDs are lit or
flashing. For more information on Mobility 1240 Access Point LED behavior, see
.
9. The access point is ready to configure.
CAUTION
If not using power over Ethernet, ensure only the Mobility 1240 Access
Point designated power supply (PWRS-14000-247R) is used to supply
power to the access point. Using an incorrectly rated power supply
could damage the access point and void the product warranty. Do not
actually connect to the power source until the cabling portion of the
installation is complete.
Wall Mount Procedure - Existing Access Point Replacement
An existing Mobility 7131 or Mobility 7131N access point, installed on a wall
(plenum installation), can be replaced by a Mobility 1240 Access Point. Simply
remove the existing Mobility 7131 or Mobility 7131N from its mounting screws,
leave the mounting hardware in place and install the new Mobility 1240 Access
Point directly on to the existing mounting hardware. The cabling procedure for such
a replacement is as described in the previous section.