Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 19)

Suspended ceiling T-Bar mount instructions
2
Brocade Mobility 1240 Access Point Installation Guide 15
53-1002917-01
CAUTION
If not using power over Ethernet ensure only the Mobility 1240 Access
Point’s designated power supply (PWRS-14000-247R) is used to supply
power to the access point. Using an incorrectly rated power supply
could damage the access point and void the product warranty. Do not
actually connect to the power source until the cabling portion of the
installation is complete.
5. Verify the unit has power by observing the LEDs. For more information on
Mobility 1240 Access Point LED behavior, see “LED Indicators” on page 23.
6. Align the bottom of the ceiling T-bar with the back of the access point.
7. Orient the access point chassis by its length and the length of the ceiling T-bar.
8. Rotate the access point chassis 45 degrees clockwise.
9. Push the back of the access point chassis on to the bottom of the ceiling T-bar.
10. Rotate the access point chassis 45 degrees counter-clockwise. The clips click
as they fasten to the T-bar.
11. The access point is ready to configure.