Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 28)

LED Indicators
2
24 Brocade Mobility 1240 Access Point Installation Guide
53-1002917-01
The LEDs provide a status display indicating error conditions, transmission, and
network activity for the 5 GHz 802.11a/n (amber) radio and the 2.4 GHz
802.11b/g/n (green) radio.
The LEDs on the bottom of the access point are optionally viewed using a single
(customer installed) extended light pipe, adjusted as required to suit above the
ceiling installations. The light pipe uses a dual LED to display the same functionality
as the LEDs on the top of the access point.
Task 5 GHz Activity LED (Amber) 2.4 GHz Activity LED (Green)
Unconfigured
Radio On On
Normal
Operation
•
If this radio band is enabled:
Blink at 5 second interval
•
If this radio band is disabled:
Off
•
If there is activity on this band:
Blink interval at 1 time per second
•
If this radio band is enabled:
Blink at 5 second interval
•
If this radio band is disabled:
Off
•
If there is activity on this band:
Blink interval at 1 time per
second
Firmware
Update On Off
Locate AP
Mode LEDs blink in an alternating green, red
and amber pattern using an irregular
blink rate. This LED state in no way
resembles normal operating
conditions. LEDs blink in an alternating green,
red and amber pattern using an
irregular blink rate. This LED state in
no way resembles normal operating
conditions