Brocade Mobility 1240 Access Point Installation Guide - Manual (Page 15)

Wall mount instructions
2
Brocade Mobility 1240 Access Point Installation Guide 11
53-1002917-01
CAUTION
To avoid problematic performance and restarts, disable POE from a
wired switch port connected to an access point if mid-span power
sourcing equipment (PSE) is used between the two, regardless of the
manufacturer of the switch.
Ensure the cable length from the Ethernet source (host) to the power over Ethernet
and access point does not exceed 100 meters (333 ft).
Wall mount instructions
A wall mount deployment requires hanging the Mobility 1240 Access Point along its
width or length using two of three slots on the bottom of the unit. The Mobility 1240
can be mounted on to any plaster, wood or cement wall surface using the provided
wall anchors.
The hardware required to install the Mobility 1240 Access Point on a wall consists
of:
• Two wide-shoulder Phillips pan head self-tapping screws (M3.5 x 0.6 x 23 mm)
• Two wall anchors
• Security cable (optional)
Optional customer provided installation tools include:
• Security cable
• Philips head screw driver, or drill and drill bit