Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 82)

NOTE
On 1000BaseSX ports, the bail latch is enclosed in a black sleeve, and on 1000BaseLX ports, the
bail latch is enclosed in a blue sleeve.
FIGURE 50 Unlocking the bail latch
1. Bail Latch
NOTE
The bail latch may be attached to either the top or the bottom of the SFP transceiver.
4. Grasp the bail latch and pull the copper or fiber-optic module out of the port.
FIGURE 51 Remove fiber-optic module
5. Store the copper or fiber-optic module in a safe, static-free place or in an anti-static bag.
6. Install a new copper or fiber-optic module in the port.
Cabling a fiber optic module
For instructions on cabling a fiber optic module refer to Cabling a fiber optic transceiversection.
Cleaning the fiber optic connectors
For instructions on cleaning a fiber optic module refer to the earlier Cleaning the fiber optic
connectorssection.
Cabling a fiber optic module
80 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02