Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 17)

1 Slot 2: Dedicated stacking ports 1, 2, 6, 7
Slot designations
The following table lists the slot designations for ICX 6610 models.
Stack unit slots for ICX 6610 stackable devices TABLE 1
Device Slot 1 Slot 2 Slot 3
ICX 6610-24 10/100/1000 Mbps ports 1-24 QSFP stacking ports 1, 2, 6, 7 SFP/SFP+ ports 1-8
ICX 6610-24F 100/1000 Mbps ports 1-24 QSFP stacking ports 1, 2, 6, 7 SFP/SFP+ ports 1-8
ICX 6610-24P 10/100/1000 Mbps ports 1-24 QSFP stacking ports 1, 2, 6, 7 SFP/SFP+ ports 1-8
ICX 6610-48 10/100/1000 Mbps ports 1-48 QSFP stacking ports 1, 2, 6, 7 SFP/SFP+ ports 1-8
ICX 6610-48P 10/100/1000 Mbps ports 1-48 QSFP stacking ports 1, 2, 6, 7 SFP/SFP+ ports 1-8
10/100/1000 BASE-T ports
All ICX 6610 copper devices provide 24 or 48 RJ45 ports that operate at 10 Mbps or 100 Mbps half or
full duplex, or at 1000 Mbps full duplex. In addition, ICX 6610 fiber models provide 24 SFP ports.
Because all ports support automatic MDI or MDI-X operation, you can use straight-through cables for all
network connections to PCs or servers, or to other switches or hubs. In addition, it is ideal (and
preferred) to use straight-through cable for switch-to-switch connections.
Each port supports auto-negotiation, so the optimum transmission mode (half or full duplex), and the
data rate (10, 100, or 1000 Mbps) can be selected automatically. If a device connected to one of these
ports does not support auto-negotiation, the communication mode of the port can be configured
manually.
SFP interfaces
The following table describes the SFP network interfaces supported on ICX 6610 devices.
Supported network interfaces TABLE 2
Interface show media command description
1000Base-BX-D M-GBXD
1000Base-BX-U M-GBXU
1000Base-LHA M-LHA
1000Base-LHB M-LHB
1000Base-LX M-LX
Slot designations
Brocade ICX 6610 Stackable Switch Hardware Installation Guide 15
53-1003082-02