Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 22)

1 Fan tray LED
FIGURE 15 Fan tray status LED on 48P-port models
Fan tray status LED TABLE 6
LED Condition Status
Fan Status Green Fan is operating normally
Yellow Fan failure
Fan trays
The device has two fan tray receptacles on the rear panel. Each device ships with one fan tray
installed. A secondary fan tray can be installed. Fan trays are hot-swappable. For instructions on
installing and replacing a fan tray refer to Installing or replacing fan trays section.
Power supplies
The device has two power supply receptacles on the rear panel. Each device ships with one AC power
supply installed. Each power supply has one standard power receptacle for the AC power cable. A
secondary AC power supply can be installed to provide backup power in case of a failure and for load-
balancing when both power supplies are operational. AC power supplies can be hot swapped.
DC power supplies are available for the device. A secondary DC power supply can be installed for
backup and load-balancing when both power supplies are operational. DC power supplies can also be
hot swapped.
Note: AC and DC power supplies cannot be installed and used in the same device. Mismatched power
supplies in the same device cause continual reboot on power up.
Fan trays
20 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02