Brocade ICX 6610 Stackable Switch Hardware Installation Guide - Manual (Page 18)

Supported network interfaces (Continued) TABLE 2
Interface show media command description
1000Base-SX M-SX
1000Base-T C
1000Base-TX M-TX
100Base-FX M-FX
40-Gbps QSFP interface stacking ports
ICX 6610 devices have two 40-Gbps QSFP stacking ports and two 4 x 10-Gbps QSFP stacking ports
on the rear panel. These ports can perform data transmission directly through copper links of up to 5
meters. ICX 6610 devices also support 40G-QSFP-SR4 at distances up to 100 meters.
Specifying a port address
You can specify a port address for a data port, stacking port, or a management port.
Specifying a data port
The port address format is stack unit/slot/port, where:
• stack unit --Specifies the stack unit ID. Range is from 1 to 8. If the device is not part of a stack, the
stack unit ID is 1.
• slot --Specifies the slot number. Can be 1 or 3.
• port --Specifies the port number in the slot. Range is from 1 to 24 (24-port models) or 1 to 48 (48-
port models).
This example shows how to specify port 2 in slot 1 of a device that is not part of a stack:
Brocade (config) # interface ethernet 1/1/2
Specifying a stacking port
The port address format is stack unit/slot/port, where:
• stack unit --Specifies the stack unit ID. Range is from 1 to 8.
• slot --Specifies the slot number. Stacking ports are in slot 2.
• port --Specifies the port number in the slot. Dedicated stacking ports are 1, 2, 6, and 7.
This example shows how to specify stacking port 2 in slot 2 of unit 3 in a stack:
Brocade (config) # interface ethernet 3/2/2
40-Gbps QSFP interface stacking ports
16 Brocade ICX 6610 Stackable Switch Hardware Installation Guide
53-1003082-02