Brocade Network OS YANG Reference Manual v4.1.1 - Manual (Page 227)

Network OS YANG Reference Manual 215
53-1003230-01
Appendix
A
Custom RPCs
Table 5 list the custom RPCs, their locations, and a brief synopsis.
TABLE 5 Custom RPCs
RPC name Host module Synopsis
activate-status brocade-firmware Returns firmware activation status.
bna-config-cmd brocade-ras Copies configuration data to and from the
system
bna-config-cmd-status brocade-ras Returns the status of the last
configuration command.
dad-status brocade-firmware Displays the current status of firmware
download.
fcoe-get-interface brocade-fcoe-ext Returns operational state details for an
FCoE interface.
fcoe-get-login brocade-fcoe-ext Returns the login information about FCoE
end nodes that have logged in to the
managed device.
fwdl-status brocade-firmware Returns the status of the firmware
download operation.
get-arp brocade-arp Returns ARP entries of the managed
entity.
get-interface-detail -ext Returns operational details of all the
possible interfaces of the managed entity.
Use this RPC to discover basic
characteristics of all the interfaces in the
system. Each sublayer below the
internetwork layer of a network interface
is considered to be an interface.
get-interface-switchport -ext Returns switch-port or Layer 2
characteristics of all the interfaces in the
managed device.
get-ip-interface -ext Return brief details of all interfaces,
loopback and VE interface details of
particular managed entity. Phy interface
details of particular managed entity
cannot be given
get-last-config-update-time brocade-vcs Returns the time stamp of the last
configuration change done on the
managed device.
get-last-config-update-time-for-xpaths brocade-vcs Returns the time stamp of the last
configuration change done on the
managed device for Xpaths.
get-mac-acl-for-intf brocade-mac-access-list Returns information about the MAC ACL
applied on the specified interfaces.