Anthro eNook Pro for Flat Screen Assembly Instructions - Manual (Page 6)

6 Questions? Call us at 800.325.3841 or visit anthro.com. We’re happy to walk you through the assembly!
steP 10
insert screw and install Frame
¡ Insert one 1-5/8" long screw into the top two TOGGLERs, but don’t tighten all the way. Leave the screw head about
1/4" from the plastic cap.
¡ Lift the Frame onto the top two screws. Install the bottom two screws, then tighten down all four screws.
For Monitor version, go to Step 11. For Laptop version, go to Step 12.
new DrAwinG neeDeD
show for the 36w monitor version.
steP 11-b
install the monitor rail onto the back Frame
¡ Determine the installation point of your Monitor Rail.
¡ Align the top of the Monitor Rail with the hole array at the top of
the Back Frame so that your monitor is where you want it. Attach
the Monitor Rail to the third row of holes frm the back of the
frame, in any left-to-right position. Use the Phillips screwdriver
and two 3/8" Phillips screws. Next align the bottom of the Monitor
Rail with the hole array at the bottom of the Back Frame. Attach
using two more 3/8" Phillips screws.
¡ If you have a second Monitor Rail, install it now.
steP 11-A
Attach the monitor Assembly to the monitor rail
¡ Select the 75mm or 100mm VESA bracket that matches the hole
pattern on the back of your monitor.
¡ Place the VESA plate in position in back of the monitor with the
cut-out toward the top of the monitor. Using a Phillips screwdriver,
attach the plate to the monitor with the four short fasteners
packaged with the VESA plate.
¡ Attach the Monitor Tilt and Pivot Mount to the VESA plate so
that the tab on the top of the mount goes into the slot on the top
of the plate. Secure using two 7.5mm screws using the Phillips
screwdriver.
¡ Orient the Monitor Rail so that the vertical hole array is at the
top. Align the two holes on the back of the Monitor Pivot Mount
with two holes on the Monitor Rail so the monitor is at the desired
height, allowing enough space for your monitor to fit inside the
enclosure. Secure the Monitor Assembly to the Monitor Rail with
the two screws that came with the Monitor Pivot Mount.
¡ If you purchased a second Monitor Rail, assemble it now.
3/8" Phillips hd screw
325-5150-00
VESA Plate
Monitor Tilt and Pivot Mount
Monitor Rail