Anthro eNook Pro for Flat Screen Assembly Instructions - Manual (Page 3)

eNook ® Pro Assembly Instructions 3
steP 1
select the mounting location
¡ When choosing the right place to install your eNook, be sure to check the location of your power source. The power cord
on the optional medical-grade power strip (p/n 935PG) is 6 ft long.
¡ Your eNook can be mounted to drywall or to wood wall studs. If you’re installing to wood wall studs, go to Step 2.
¡ If you’re installing into drywall, go to Step 7.
steP 2
Find wall studs
¡ Using a stud finder, locate the studs to which you'll attach your eNook.
steP 4
Attach screws to wall studs
¡ Using a 1/8" drill bit, drill one hole into a stud about
1-1/2" deep. How do you make sure that hole is
1-1/2" deep? Measure that length on your drill
bit and mark it with a piece of masking tape. Stop
drilling when you reach the masking tape.
¡ Using a Phillips driver (or a power driver with a
Phillips bit), attach the first 1-1/2" long screw at that
mounting point, but don’t tighten all the way to the
wall. Stop tightening when the screw head is about
1/4" away from wall.
Drill
Wall Stud Profile
1½"
Tape ¼ "
Screw
steP 3
Determine mounting Point
¡ Determine the optimal desk height for your eNook.
Typical sitting height is about 29" high; typical
standing height is about 42" high.
¡ For the 36w eNook Pro, measure up 14-3/4" from the
shelf location and mark that point on one stud. For
the 28w eNook Pro, measure up 14-1/4" from the
shelf location and mark that point on one stud.
14.75"
23"
36w version shown
1-1/2" screw
325-5358-00