Renkus-Heinz ICL-R User Manual

Page 66

ive Users Manual - Models ICL-R & IC215S-R

Sensitivity:

Freq. Range:

Max SPL:

Horiz. Dispersion:

Vert. Opening Angles:

Aiming Angle:

Typical Throw:

Beam Control:

№. Transducers:

(per module)

№. Amp. Channels:

Dimensions:

Weight:

Hanging Method:

Enclosure:

Inputs:

Controls (Rear Mounted):

Computer Controls:

Status Indicators:

Power Connector:

Finish:

Network Digital Format:

DSP/AMPLIFIER

Type:

Input Impedance:

M ax Input:

Power Rating:

Freq. Range:

THD Distortion:

Hum & Noise:

Power Required:

(per module)

01.0 V (for rated power output)
80 Hz to 20 kHz
105 dB peak @ 100 Ft. (30.5 meters),

108 dB peak when stacked

(3-octave bandwidth centered at 2 kHz)
150° up to 3 kHz; 120° above 3 kHz
20°, 25° and 30° (5°, 10°, 15° and 20° when stacked)
Adjustable from -30° to +30°
66 Ft. (20 m) 132 Ft. (40 m) when stacked
Effective down to 800 Hz (400 Hz when stacked)
Five 6.5-inch cone transducers with neodymium magnets

Three 1-inch HF titanium nitride compression drivers
8 (per module)
48” H x 8” W x 11.3” D (121.5 cm x 20. cm x 28.7 cm)
61 Lbs (27.7 Kg)
AeroQuip Fly-Track
Finnish Birch with Aluminum end caps and

perforated steel grille; suitable for outdoor use
Analog Audio - AES/EBU Inputs: Looping XLR (female in, male out)

and Phoenix 6-pin (looping 3-in, 3-out)

CobraNet: Dual RJ45 connectors (for CAT 5)
Mute button; Up & Down Output Level push buttons; 10 dB Input pad (on Analog 1

input),Power On/Off,; Push-To-Reset circuit breaker; Configuration PreSet Selector
Gain; Mute; On/Standby, Input Selection; Compression, 8-Band Parametric EQ,

Shelving & Rolloff Filters; Delay, Configuration Preset Readout
Power, Signal, Overdrive, Thermal, Mute, Input Pad, Failure, Preset Configuiration
Powercon locking connector
Black paint
16, 20 or 24 bit PCM; 48 or 96 kHz sample rate; selectable network latency

8-channel, Class D amplifier/DSP processor

>20K Ohm balanced differential

+24 dBu (Pad in 0; +14 dBu @ 1V sensitivity (Pad out)
100 Watts RMS per channel, 150 Watts Burst
+ 3, - 3 dB, 80 Hz to 20 kHz
< 0.05% typical
<100 dB (A weighted)
Universal 90/260 VAC, 50/60Hz.

500 VA @ Rated Power Output; 29 VA Idle;

(4.2 Amps @ RPO at 120 V; 250 ma Idle)

ICL-R Technical Specifications

Note: All analog inputs and outputs comply with AES Standard 48-2005 on interconnecting, grounding and shielding.