Nexo NUAR User Manual
Page 69
MENU DESCRIPTION
If GPInput1 is ‘High’, Channel 1 will be muted. If GPInput1 is ‘Low’, Channel 1 will be
unmuted. Front Panel mute/Unmute is still working.
If GPInput2 is ‘High’, Channel 2 will be muted. If GPInput2 is ‘Low’, Channel 2 will be
unmuted. Front Panel mute/Unmute is still working.
If GPInput3 is ‘High’, Channel 3 will be muted. If GPInput3 is ‘Low’, Channel 3 will be
unmuted. Front Panel mute/Unmute is still working.
If GPInput4 is ‘High’, Channel 4 will be muted. If GPInput4 is ‘Low’, Channel 4 will be
unmuted. Front Panel mute/Unmute is still working.
If GPInput5 is ‘High’, Amplifier will go to Stand-by mode. If GPinput5 is ‘Low’, Amplifier will
go back to running mode.
GPOutput1 is ‘High’ only if CH1 amplifier reports no fault AND the NXAMP is able to
measure the impedance of the speaker(s) connected to CH1 AND this impedance is
between the high and low impedance limits set up by the user (see Load monitoring
menu).
GPOutput2 is ‘High’ only if CH2 amplifier reports no fault AND the NXAMP is able to
measure the impedance of the speaker(s) connected to CH2 AND this impedance is
between the high and low impedance limits set up by the user (see Load monitoring
menu).
GPOutput3 is ‘High’ only if CH3 amplifier reports no fault AND the NXAMP is able to
measure the impedance of the speaker(s) connected to CH3 AND this impedance is
between the high and low impedance limits set up by the user (see Load monitoring
menu).
GPOutput4 is ‘High’ only if CH4 amplifier reports no fault AND the NXAMP is able to
measure the impedance of the speaker(s) connected to CH4 AND this impedance is
between the high and low impedance limits set up by the user (see Load monitoring
menu).
GPOutput5 is ‘High’ only if amplifiers of each channel reports no fault AND the NXAMP is
able to measure the impedance of the speaker(s) connected on all outputs AND these
impedance are between the high and low impedance limits set up by the user (see Load
monitoring menu).
GPOutput6 is ‘High’ only if amplifiers of each channel reports no fault (useful to monitor
amp status only if loudspeaker impedance monitoring is not used).
GPOutput7 and GPOutput8 are not used.
PAGE 69 OF 140