Gpio mode 4 (cp4sw setup switcher mode) – Nexo NUAR User Manual
Page 67
MENU DESCRIPTION
GPOutput4 is blinking each time a decrease volume command is received, and is ON when
volume is set to min.
GPOutput5 reflects the GPInput1 (with a small delay and without glitches).
GPOutput6 reflects the GPInput2 (with a small delay and without glitches).
GPOutput7 reflects the GPInput3 (with a small delay and without glitches).
GPOutput8 reflects the GPInput4 (with a small delay and without glitches).
GPIO mode 4 (CP4SW setup switcher mode)
This mode is intended to be used with momentary "High" signals (like push buttons). It is
recommended to use the Yamaha CP4SW remote control panel for DME. Connect the
button 1 to 4 to the GPI 1 to 4, and each LED to GPO 1 to 4. Here is the detail:
Pin Name
In/Out
On each Impulse (From 0 to 1 and back to 0)
GPInput 1
In
Select scene 1
GPInput 2
In
Select scene 2
GPInput 3
In
Select scene 3
GPInput 4
In
Select scene 4
GPInput 5
In
Unused
Pin Name
In/Out
Meaning when set to 0
(Default)
Meaning when set to 1
GPOutput 1
Out
Scene 1 not in use
Scene 1 in use
GPOutput 2
Out
Scene 2 not in use
Scene 2 in use
GPOutput 3
Out
Scene 3 not in use
Scene 3 in use
GPOutput 4
Out
Scene 4 not in use
Scene 4 in use
GPOutput 5
Out
GPInput 1 impulse out to other amp
GPOutput 6
Out
GPInput 2 impulse out to other amp
GPOutput 7
Out
GPInput 3 impulse out to other amp
GPOutput 8
Out
GPInput 4 impulse out to other amp
When an impulse is detected on GPInput1, User setup 1 is recalled. Warning: Any setup
can be recalled, regardless of the loudspeaker family.
When an impulse is detected on GPInput2, User setup 2 is recalled. Warning: Any setup
can be recalled, regardless of the loudspeaker family.
When an impulse is detected on GPInput3, User setup 3 is recalled. Warning: Any setup
can be recalled, regardless of the loudspeaker family.
When an impulse is detected on GPInput4, User setup 4 is recalled. Warning: Any setup
can be recalled, regardless of the loudspeaker family.
PAGE 67 OF 140