Nexo NUAR - Manual (Page 45)

MENU DESCRIPTION
NB: You can adjust large differences of gain between channels with the volume menu.
There is no difference between gain and volume setting; this distinction is only done by
analogy with traditional amplifiers. The CPU will always check gain, volume, patch and
headroom settings and decide what the best combination is between analog or digital gain
to optimize the dynamic range of the system.
Adjusting Delay
The delay of each channel can be adjusted from the Delay menu. Bellow is a picture of this
menu.
The delay value can be read on the top of the LCD screen for each channel (unit is meters).
To change the delay for a given channel, select the channel first by pressing the
corresponding ‘Select’ button. The channel name on screen will then be put between
bracket (see on the picture above, channel 2 is selected). Then turn the wheel to change
the delay setting (maximum delay is 66.6 meters).
You can select multiple channels by pressing several ‘Select’ buttons at the same time.
When a selected channel reaches the maximum value, it will cease to increase by
continuing to turn the wheel, but other selected channels may still increase the setting: be
careful not to change a gap between two channel settings when selecting multiple channels
at the same time.
In some special situation (active setups in same enclosure for example, like PS15 active) it
is mandatory to have same delay settings on two or more channels. Then, changing the
delay on one of these channels will automatically adjust the delays on the other channels.
See the “Miscellaneous” menu for delay unit adjustment.
Adjusting Gain
The gain of each channel can be adjusted from the Gain menu. Bellow is a picture of this
menu.
PAGE 45 OF 140