Graphical user interface, Nabling remote control of, Nxamp – Nexo NUAR User Manual
Page 105: With, Nxdt104, Monitor, Raphical user interface
NXDT104 EXPANSION BOARD, DANTE™ PATCHING AND REMOTE CONTROL
NEXO provides in each revision of the NXAMP firmware the last version of the ESmonitor™
software that has been successfully tested with this firmware. It is recommended to use
this specific version of the ESmonitor™ software.
Please refer to the ESmonitor™ User Manual provided by Auvitran as a pdf file when
installing the ESmonitor™ application on your computer. Once completed, you can access
to the control page of the NXAMP Powered TDcontroller.
Enabling remote control of NXAMP with NXDT104 in ESmonitor™
To enable the monitoring of NXAMP on a Dante™ network through ESmonitor™, you have
to check the Enable Dante™ device control option in the AVS-Control Panel (installed
together with the ESmonitor™ software).
NB: This option is only available from ESmonitor™ v3.16.9
WARNING! Do not use ESservice on a distant computer when the Dante™ device
control is enabled.
Graphical user interface
Picture bellow shows the control page when using ESmonitor™ v3.18.0 and LOAD3_15 on
an NXAMP powered TDcontroller with NXDT104 fitted.
PAGE 105 OF 140