Stuart Turner 3.2 bar PS - Manual (Page 12)

- 12 -
STEP 7 COMMISSIONING
WARNINGS:
 The motor casing can become very hot under normal operating
conditions, care should be taken to ensure it cannot be touched during
operation.

Do not run pump without guards and terminal box lid correctly fitted.
 The pump chamber must be full of water at all times. Seal damage will
result if the pump runs dry.
1. System Flushing
This pump incorporates push-in connectors and plastic components that
must not come into contact with solder flux, acid-based descalents or
aggressive cleaning agents. The pipework system should be flushed out
prior to the pump being connected to ensure any contaminants/chemical
residues and foreign bodies are removed from elsewhere in the system.
2. Water Supply
Always ensure that water storage capacity is adequate to meet the demand.
Ensure the pump chamber is full of water before starting the pump. Failure
to do this could result in seal damage. To ensure dry running does not
occur the pump must be primed as described in the priming section. Do
not run pump dry.
3. Priming
The pump must be primed (filled with water) before starting. Turn on water supply,
prime and vent the pump by unscrewing the priming plug (Figs. 13 & 14) slowly
until all air escapes and water emerges. Re-tighten the plug.
Monsoon Extra 3.2 PS
Fig. 13 Monsoon Extra 4.7 PS
Fig. 14
Priming
Plug
Priming
Plug