Stuart Turner Submersible Diver 35 & 45 Boostamatic - Manual

- 1 -
Cont ...
Supplementary Instruction Sheet
- Boostamatic Diver Pumps -
The following information is to be read in conjunction with operation booklets, supplied
with the pump and control module.
IMPORTANT NOTES
 Please read these instructions fully before starting the
installation.
 The installation must comply with the relevant water supply,
electrical and building regulations and be installed by a
competent person.

If in doubt, consult Stuart Turner Ltd.
 Further information can be found in the individual Diver and
Control Module instruction books.
APPLICATION
The Boostamatic Diver range is designed for pressure boosting applications in clean
fresh water systems, where under gravity, no flow is available.
WARNING AGAINST MISUSE

This pump set must not be used for any other application without the
written consent of Stuart Turner Limited and, in particular, must
not be connected directly to the mains water supply or used outside the
conditions specified in the limits of application.

This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
 Children should be supervised to ensure that they do not play with the
appliance.
PRODUCT DESCRIPTION
Control Module
All models use the solid state IP65 rated pressure control module, mounted remotely
with the Diver units. The wetted materials of construction are brass, rubber and nylon 66.