Performing read and write tests, Performing read and write tests -16, Performng read and wrte tests – Yokogawa DAQWORX User Manual
Page 27
2-16
IM WX1-07E
Performng Read and Wrte Tests
You can check the data of the registers specified in the input tab page (monitor
execution) by performing a read test.
Also, you can perform a write test to the registers specified in the output tab page during
monitor execution.
Note
The Read and Write tests cannot be performed during data acquisition.
Procedure
Performng a Read Test
1.
Click the Detail Settings button in the Model Settings tab page of the model on
whicih you wish to perform the read test.
The Tag Settng dialog box opens.
Click to display the Tag Settings dialog box
Monitor Stop and Output Test Buttons
Monitor execution
results
Output test
results
Specifies the output
values during the
output test
Drag to select the tag on which
to perform the output test
Monitor start button
2.
Click the Start montor button.
The value of each tag from the instrument is loaded, and displayed in the loaded
value column of the input tab sheet.
To quit monitor execution, proceed to step 6.
2.5 Performng Communcaton Tests of Connected Devces