Yokogawa µR10000 - Manual (Page 30)

30
IM 04P01B01-02E
Installing/Replacing the Plotter Pen (Pen Model)
1. Open the door.
If recording is in progress, press the RCD key to stop the recording.
2. Open the display and key panel section.
3. Hold the plotter pen cartridge and pull it out from the pen holder.
4. Remove the cap from the new plotter pen and insert the pen firmly into the pen
holder.
5. Return the display and key panel section to its original position.
Installing/Replacing the Ribbon Cassette (Dot Model)
CAUTION
• Improper cassette insertion may cause the color to change or damage the ribbon.
• Do not apply upward force to the printer carriage. If you do, the carriage position
may be offset, and the recorder may not print correctly.
1. Open the door.
If recording is in progress, press the RCD key to stop the recording.
2. Press the FUNC key.
3. Press the ( DISP ) key several times to display R.exchange.
Func=R. exchange
4. Press the ( CH UP ) key.
The printer carriage moves near the center position, and R. exchange = End is
displayed.
5. Open the display and key panel section.
You can open the display and key panel section by holding the tab at the lower
left and pulling it toward you.
Note
If the recorder is OFF, hold the printer carriage and move it near the center position.
Printer carriage
* When the key or key is pressed while holding down the SHIFT key, the operation is reversed as
when the respective key is pressed by itself.
Preparing to Record