Yokogawa FieldMate - Manual (Page 27)

<4 Device Tag Extension Mode>
4-1
IM 01R01A20-01E
4 Device Tag Extension Mode
 Outline of PRM/FieldMate synchronization compatibilities
Devices with extended device tag are recognized and handled according to HART Device
Tag Display Format such as “Tag + Descriptor” or “Descriptor” or “Message” on both PRM and
FieldMate sides.
On PRM R3.03 or later and FieldMate R2.01.10 or later, the extended device tag generated as
the result of HART Device Tag Display Format in PRM are recognized and fully supported by
FieldMate (and vice versa).
NOTE
When it is enabled, settings must be exactly the same on both sides. Otherwise, PRM/
FieldMate Synchronization displays an error message and exit.
However, FieldMate does not recognize the Device Tag Extension mode for STARDOM Project
Name Support as described example in the following sheet.
 Preconditions for PRM/FieldMate Synchronization
This table summarizes the conditions where PRM/FieldMate Synchronization are allowed.
Device Tag Extension mode for STARDOM Project Name Support is ignored when FieldMate
synchronizes with PRM.
Table 4-1 Preconditions for PRM/FieldMate Synchronization
Device Tag Extension
Mode
FieldMate
R1.03/
R2.01.00
FieldMate
R2.01.10/R2.02/R2.03/R2.04/R2.05/R2.06
FieldMate
R2.02/
R2.03/
R2.04/
R2.05/
R2.06
STARDOM
Project
Name
HART Device
Tag Display
Format
HART Device Tag Display Format
Tag
Tag +
Descriptor Descriptor Message Long Tag
PRM R3.02 - - √ √ Ч Ч Ч Ч
PRM R3.03
PRM R3.04
PRM R3.05
Off Tag √ √ Ч Ч Ч Ч
Tag + Descriptor Ч Ч √ Ч Ч Ч
Descriptor Ч Ч Ч √ Ч Ч
Message Ч Ч Ч Ч √ Ч
On Tag √ √ Ч Ч Ч Ч
Tag + Descriptor Ч Ч √ Ч Ч Ч
Descriptor Ч Ч Ч √ Ч Ч
Message Ч Ч Ч Ч √ Ч
PRM R3.05
PRM R3.10
PRM R3.11
Off Long Tag Ч Ч Ч Ч Ч √
Note
On
√ : Synchronization is effective.
×: Synchronization is not effective.
Note: When Long Tag is specified for HART6,7 devices, setting of HART5 devices follows the bold line of individual Device Tag
Extension Mode shown above.
8th Edition : May 31, 2013-00