Yokogawa FieldMate - Manual (Page 26)

<3 PRM Synchronization Tool start>
3-17
IM 01R01A20-01E 8th Edition : May 31, 2013-00
 Searching for a device
The Device Navigator provides a search facility to help you look for devices.
030312E.ai
Figure3-12 Search pane
To use search:
1. Select [Search] from the Device Navigator. The Search pane appears.
2. In the Search pane, select a category from the [Look In] drop-down list.
3. Select the search criteria from the [Criteria] drop-down list.
4. Enter the search keyword in [Values] or select a recently-used keyword from the drop-down
list.
• [...] button next to Values is effective when Vendor, Model, Device Revision,
Communication Type is selected in Look In to assist user to search available values.
If necessary, select a logical operator from the [Logic] drop-down list.
• If several conditions are specified, refer to example below. Bracket ( ) comes before and
after OR logic. For example: 1 AND 2 OR 3 AND 4 AND 5 OR 6 means that (1 AND 2)
OR (3 AND 4 AND 5) OR 6
5. Click [Add] to insert the search criteria.
6. Click [Search] to start the search based on the search criteria. The search output will be
displayed at the bottom of the right pane.
7. Select devices from the search result. To select devices, select the check box next to the
device tag. A check mark appears to indicate that the device is selected.
• To add other search criteria, enter a new keyword and then click [Add].
• Click [Delete] to remove the search criteria.
• Click [Change] to apply updates.
• Click [Reset] to clear both the list and search results.