Yokogawa FieldMate - Manual (Page 24)

<3 PRM Synchronization Tool start>
3-15
IM 01R01A20-01E 8th Edition : May 31, 2013-00
 Parameter sets
You can configure the parameter set for each selected device. FieldMate can support up to five
parameter sets for each device. When this limit is reached, FieldMate will automatically overwrite
the oldest parameter set.
You can select parameter sets either automatically or manually. In the Synchronize activity, both
PRM and FieldMate parameter sets can be manually selected. In the Restore activity, only PRM
parameter sets can be manually selected.
030310E.ai
Figure3-10 Advanced Configurations dialog box – Parameter set tab
To select parameter sets:
1. Under Data Options, select the [Parameter] check box. A check mark appears and the
options in the Parameter tab are enabled.
The options in the tabs are only enabled after you select the corresponding Data Options
check box.
2. Click a Device Tag to select a device.
3. Choose a parameter set selection mode:
• Click [Auto-Selection] and then select one of the drop-down list options:
Table3-6 Auto-Selection options
Auto- Selection options Definition
The latest dated ‘Do not
Archive’ set and latest date set
Selects the latest parameter set that has been assigned with the Do not
Archive key and the latest dated set option. If the latest parameter set has
been assigned with the Do not Archive key, only one parameter set will be
selected.
The latest dated ‘Do not
Archive’ set
Selects the latest parameter set that has been assigned with the Do not
Archive key.
The latest dated set Selects the latest parameter set, regardless of the assignment of the Do not
Archive key.
• Click [Manual Selection] and then manually select the parameter sets to be included in
the activity. You can select up to five parameter sets.