Progressive International Electronics RLM - Manual (Page 16)

Progressive International Electronics RLM
Version 1.1 / November 98 Page 7
rlminstl.mnl
3. Referring to Connector/Jumper Layout diagram on the next page,
set all jumpers on the RLM main board according to the specific
application requirements. These settings affect the Tank Monitor
communications parameters such as baud rate, parity, data bits
and device addressing. Also, these jumpers allow the RLM to be
configured for daisy-chaining together using RS485 multi-drop
circuitry. Reference the three diagrams at the end of this
section.
4. Connect a PC to the installed RLM’s communication cable.
5. Plug the wall transformer into the dedicated power outlet to apply
power to the RLM system.
6. Run Tester Program supplied on the system diskette shipped with
the RLM, and perform a preliminary test. Refer to Tester
Program, Preliminary Test in the Diagnostics section of this
manual.