Warnings – Ramsey Winch RPH 42,2 User Manual
Page 4
SPECIFICATIONS*
* Rope Capacity Per Layer
WARNINGS:
THE USER SHALL ENSURE THAT THE OPERATING PERSONNEL ARE GIVEN THE NECESSARY TRAINING.
THE OPERATOR SHALL ALWAYS WORK IN COMPLIANCE WITH THE OPERATING INSTRUCTIONS.
A MOTOR SPOOL (OPEN CENTER) DIRECTIONAL CONTROL VALVE IS REQUIRED FOR BRAKE OPERATION.
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF ROPE WHILE PULLING. DO NOT TRY TO GUIDE ROPE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PERSONNEL.
A MINIMUM OF 2 WRAPS OF ROPE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
IN CAR CARRIER APPLICATIONS, AFTER PULLING VEHICLE ON CARRIER, BE SURE TO SECURE VEHICLE TO CARRIER
BED. DO NOT MAINTAIN LOAD ON WINCH ROPE WHILE TRANSPORTING VEHICLE. DO NOT USE WINCH AS A TIEDOWN.
AVOID CONDITIONS WHERE LOAD SHIFTS OR JERKS OCCUR. EXCESSIVE “INCHING” SHALL BE AVOIDED.
USER’S RESPONSIBILITY FOR CE COMPLIANCE
1.
Use only a motor spool (open center) control valve Per Hydraulic System Requirements.
2.
If a remote-operated winch control valve is used, refer to Hydraulic System Requirements for Emergency Stop
components to be installed.
3.
Adjust system relief pressure per Hydraulic System Requirements
4.
Mount winch per Winch Mounting Instructions.
5.
Install 11 mm (.433 inch), grade 1960 wire rope. For STD drum, maximum rope length of 36 M (120 ft) for four
layers maximum. For Y drum, maximum rope length of 24 M (80 ft) for four layers maximum.
Attach rope to the drum per Rope Installation Instructions. Hook must have a safety latch and a minimum breaking
strength of 106 kN.
4
First Layer Line Pull
42,2 kN (9480 lb)
Noise Level
75 db
Ambient Temp. Range
-28C to 60C (-20F to 140F)
Gear Reduction
5.1:1
Weight (without rope)
STD. DRUM 49,9 Kg (110 lb)
"Y" DRUM 47,6 Kg (105 lb)
LAYER OF ROPE
1
2
3
4
Line pull per layer
kN
42,2
35,2
30,2
26,4
lb
9,480
7,900
6,700
5,900
STD. DRUM
m
6
15
24
36
ft
20
50
80
120
"Y" DRUM
m
4
9
16
24
ft
15
30
55
80
* Line Speed at
56,7 LPM
(15 GPM)
MPM
9,7
11,2
13,0
14,8
FPM
32
37
43
49
* These specifications are based on recommended wire rope of 11 mm (.433") 1960
grade wire rope and a 408 cc (24.9 cu in) /Rev. motor.