Ramsey Winch DODGE WRAPAROUND KIT 295252 - Manual (Page 7)

KI-913275-0999-G 6
STEP 5
2. Attach R.H. & L.H. brace #4& #5 to bottom of winch mounting channel #6, as shown below. Use (1) 3/8-16NC X
1-1/2” capscrew #14 each side. Insert capscrew through flatwasher (included with winch), brace, winch mounting
channel, and thread into front feet of winch as shown below.
3. Secure back feet of winch using remaining winch mounting hardware furnished with winch.
4. Attach remaining end of braces to brackets #2 & #3 using (1) 3/8-16NC x 1 lg. hx.hd. capscrew #15 with
lockwasher #26 and nut #20, (each side) as shown below .
5. Square mounting frame, side plates and brackets with front of vehicle by tightening adjuster screw until kit is level
(refer to VIEW A-A, pg. 3). Tighten lock nuts #21 against brackets
1. Tighten all hardware to proper torque value (see TORQUE VALUE CHART).
4. Refer to winch Owner's Manual Installation Instructions for electrical connections.
a. Route free end of red and black battery cables up to battery and secure to terminals using spacers #33, as shown
below.
b. BE SURE BATTERY CABLES ARE NOT DRAWN TAUT ACROSS ANY SURFACES WHICH COULD POSSIBLY
DAMAGE THEM. Use cable ties #30 and loom #34 to secure cable and wires to a location of the installer's
discretion, behind vehicle grille.
c. Plug remote switch into receptacle of black solenoid cover of winch. Run winch forward and reverse to check
connections. Snap appropriate "IN" and "OUT" disc into proper thumb cavity, after determining winch-operating
direction. DO NOT LEAVE SWITCH PLUGGED IN WHEN WINCH IS NOT IN USE.
5. Place end of wire rope through fairlead and attach clevis hook. Use clevis pin and cotter pin (furnished with winch).
REFER TO WINCH OWNER'S MANUAL FOR SAFE OPERATIONS.