Ramsey Winch DODGE WRAPAROUND KIT 295252 - Manual (Page 11)

KI-913275-0999-G 10
VEHICLE FRAME MOUNTING HOLE CHANGE
Beginning with vehicles manufactured in January 1999, Chrysler has modified the vehicle frames of the full
size Dodge Ram truck by moving the location of the horizontal slot and adding a hole. Look carefully at the
diagram below to determine which hole configuration is on your vehicle frame.
If your frame looks like the
“old hole pattern”, disregard the rest of the instructions in this section and return to Step 2 on page 3. If
your frame looks like the “new hole pattern”, use the instructions in this section for mounting the left and
right bracket assemblies. All other instructions are unchanged.
2. Thread (1) 3/8-16NC x 1-1/2 capscrew #14 through lock nut #21 and through nut welded to bracket #3.
3. If vehicle is not equipped with tow hooks, this kit requires spacer plate #31 (Refer to Paragraph 4) to be
used.
4. Mount R.H. bracket #3 as shown, adding spacer plate #31(if required). Using (1) 7/16-14NC x 1-1/2 lg.
hx.hd. capscrew #16, insert through front hole of bracket, then through spacer plate #31 (if required) or
tow hook and then through bumper mounting bracket and winch mounting channel. Attach with
flatwasher #28, lockwasher #27 and nut #22 as shown. DO NOT TIGHTEN.