Ramsey Winch DODGE WRAPAROUND KIT 295252 - Manual (Page 10)

KI-913275-0999-G 9
8. See Detail A for proper location to drill holes, then follow steps below for mounting solenoid assembly.
9. Mount solenoid assembly to the front side of the vehicle frame crossmember as follows:
a. Mark and center punch crossmember (see diagram below for dimensions).
b. Drill (2) 5/16” dia. holes through the crossmember at the location shown below.
c. Attach solenoid assembly to crossmember using (2) ¼-20NC x ½” hex head capscrews with
lockwashers (furnished with winch).
d. Insert capscrews through lockwashers, then through back of vehicle crossmember, then through
flatwashers #24, and thread into captive nuts in bottom of solenoid assembly. Tighten hardware
securely.
10. Re-install vehicle bumper as follows:
a. Secure bumper with (1) 7/16-14NC x 1-1/2” capscrew #16, with flatwasher #28, lockwasher #27,
and nut #22 in upper hole (each side).
b. Align bumper with headlamps, maintaining a ¾” gap between top of bumper and bottom of
headlamps on each side. Tighten hardware to proper torque. (See torque value chart).
PLEASE CHECK VEHICLE FRAME MOUNTING HOLE CHANGE ON NEXT PAGE BEFORE
PROCEEDING FURTHER.