Ramsey Winch DODGE WRAPAROUND KIT 295252 - Manual (Page 2)

KI-913275-0999-G 1
STEP 1
1. Vehicles equipped with factory tow hooks do not use spacer plate #31 (Refer to Step 2, Paragraph 4). If
vehicle is equipped with a lower air-dam, it must be modified to the diagram below or removed. The
notches and holes must be added for clearance of brackets #2, & #3 and braces #4 & #5 installed in a
later step.
NOTE: It is not necessary to remove the air-dam to add the notches and holes. It is easier to make the
cutouts with the air dam in place.
NOTE: IF YOU ARE INSTALLING A PRO-8000 OR PRO-9000 SERIES WINCH ON A 1998 OR 1999
VEHICLE ONLY, PLEASE GO TO PAGE 8 OF INSTRUCTIONS.
2. Remove vehicle bolt bracket from R.H. side of vehicle frame and discard bracket and nuts.
3. Install (1) 7/16-14NC x 1-1/2 lg. capscrew #16 with flatwasher #28, lockwasher #27, and nut #22 in
upper hole to hold vehicle bumper in place. Tighten capscrew to proper torque value (see TORQUE
VALUE CHART). Next, remove vehicle bumper mounting bolt and nut from vehicle frame and discard.
4. Repeat for L.H. side of vehicle.