Ramsey Winch DODGE WRAPAROUND KIT 295252 - Manual (Page 5)

KI-913275-0999-G 4
6. Place 1/2” nut extender #10 through hole in vehicle frame just below bumper strut. NOTE: It is necessary
to temporarily loosen strut-mounting hardware and shift strut clear until extender is attached. Install (1)
1/20--13NC x 1-1/2" lg. capscrew #17 with lockwasher #29 through bracket #3, as shown in VIEW A-A,
and thread into nut of nut extender (each side).
7. Shift vehicle bumper strut back into place and reinstall bumper strut mounting hardware.
Repeat 2-7 for L.H. bracket
After brackets are mounted to vehicle frame, tighten adjuster screw firmly against bottom of vehicle frame,
and tighten lock nuts against brackets.
STEP 3
1. You will need assistance for this step.
2. Have someone hold the winch mounting channel #6 between brackets #2 & #3.
3. Position R.H. side plate #7 to outside of bracket #3 as shown below.
4. Insert (2) 3/8-16NC x 1-1/2 lg. carriage bolts #13 through side plates, mounting bracket and winch
mounting channel as shown below. Secure using 3/8” lockwasher #26 and 3/8” nut #20 for each
carriage bolt.
5. Repeat for L.H. side.
6. Finally, insert 3/8-16NC x 1-1/2 lg carriage bolt #13 through rear hole of side plate and into mounting
bracket as shown below. Secure using 3/8” lockwasher #26 and 3/8” nut #20.
7. Repeat for L.H. side.
DO NOT TIGHTEN HARDWARE