Ramsey Winch DODGE WRAPAROUND KIT 295252 - Manual (Page 3)

KI-913275-0999-G 2
5. NOTE: INSTRUCTIONS ON THIS PAGE APPLY ONLY TO PRO-8000 OR PRO-9000 SERIES
WINCHES ON A 1994-1997 VEHICLE. For all other winches, go to page 3.
a. If you are mounting a Pro-8000 or Pro-9000 series winch on a 1998 or 1999 vehicle, please use the
alternate instructions on page 8.
b. If you are mounting a Pro-8000 or Pro-9000 series winch on a 1994–1997 vehicle use the instructions
on this page.
6. Mount solenoid assembly to the front side of the vehicle frame crossmember as follows:
a. Mark and centerpunch crossmember on the back (See diagram below for dimensions).
b. Drill (2) 5/16” dia. holes through the crossmember at the location shown below.
c. Attach solenoid assembly to crossmember using (2) ¼-20NC x ½” hex head capscrews with
lockwashers (furnished with winch).
d. Insert capscrews through lockwashers, then through back of vehicle crossmember, then through
flatwashers #24, and thread into captive nuts in bottom of solenoid assembly.
e. Tighten hardware securely.
NOTE: PLEASE READ INSTRUCTIONS ABOUT VEHICLE FRAME MOUNTING HOLE
CHANGE ON LAST 2 PAGES BEFORE YOU CONTINUE!