Ramsey Winch RPH-50000 SHORT DRUM W/AIR TENSIONER & 2-SPEED MOTOR User Manual

Page 21

Text mode
Original mode

5. Insert the pin (item #3) through the bracket (item

#5) and secure with the washer (item #10) and

cotter pin (item #11). Replace nuts (item #8) and
tighten to 8-10 ft-lbs. torque.

6. Center the tensioner bar between the drum

flanges. Loosen (do not remove) the mounting
bolts (item #7) and center with a scale or tape
measure. Tighten the mounting bolts to 60-70 ft-
lbs. torque.

7. Reconnect the air supply to the “T” fitting (item

#12) on the cable tensioner. Do not tighten more
than 1/4 turn beyond hand tight. If the cable was
removed, do not energize the cable tensioner until
the cable is installed. See the instructions on
page 6.