Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT - Manual (Page 9)

7
5. Remove gear housing cover (item #7) from
gear housing (item #11) by unscrewing cap-
screws (item #19). Thread two of the cap-
screws into the two tapped holes of cover
and tighten. This will pull the cover loose
from gear housing.
Remove cover gasket (item #31) and pull
shaft (item #14), with gear attached, and
thrust washer (item #47) from gear housing.
6. Check for signs of wear on gear teeth. If re-
placement of gear is necessary, replace as
fol lows:
a. Press gear (item #9) from shaft (item #14).
b. Examine shaft keys and keyways. If dis-
tor tion of keys and/or keyways is evident,
shaft and keys should be replaced.
c. Use a soft hammer to gently tap keys (item
#33) into keyways. Press gear (item #9)
over shaft and keys. Gear must be cen-
tered over keys.
7. Remove seal (item #43) from back of gear
housing (item #11). Press bushing (item
#18) from gear housing. Press new bushing
and seal back into place.
8. Check drum bushings (item #17) for signs of
wear. Replace if necessary by pressing old
bushings from drum. Press new ones into
place.