Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT - Manual (Page 10)

8
9. Examine shifter assembly (item #1) for
damage to yoke. Yoke should be fi rmly
attached to shaft, yet able to swivel freely
around shaft. Replace if necessary.
Install new shifter assembly (item #1) by
placing end of shaft, opposite yoke,
through spring (item #45) and into hous-
ing (item#12).
10. Check cover bushing (item #17) for
signs of wear. If necessary remove old
bushing and press bushing into place.
11. Apply grease to end of shaft, opposite
ge ar. Apply grease to bushing in gear
housing (item #11). Place greased end of
shaft through thrust washer (item #47) and
bushing in gear housing (item #11). Place
gasket (item #31) onto gear housing cover
(item #7). Apply grease to gear end of
shaft and cover bushing. Place cover onto
shaft and secure to housing with ten cap-
screws (item #19). Tighten capscrews to
8 ft. lbs. (10.8 Nm) each.
12. Press bearing (item #16) onto worm
(item #15). NOTE: Be sure that thick
shoulder of bearings outer race (side
with manufacturer’s name and part
number) is out, away from worm
threads. Press bearing and worm into
gear housing. Slip new gasket (item
#30) onto brake housing. Use four cap-
screws (item #22) to secure brake hous-
ing to gear housing. TIGHTEN
CAPSCREWS TO 8 FT. LBS. (10.8
Nm.) EACH. See re-assembling
and checking the brake on page 13
to complete brake assembly.