Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT - Manual (Page 12)

10
16. Attach angles (item #3 & #4) using six
capscrews (item #21) with lockwashers
(item #27) and two capscrews (item #20)
with lockwasher (item #27). Torque cap-
screws to 34 ft. lbs. (46 Nm.) each. Insert
plug (item #38) into bottom of gear hous-
ing. Permatex may be applied to threads
to help prevent leakage.
Attach handle (item #10) to clutch shaft
using pin (item #39).
Pour 1 pint of SAE 140 EP gear oil into
housing through hole in top of housing.
Insert relief fi tting (item # 35) into reducer
(item #37). Reducer should then be placed
into hole on top of gear housing. Tighten
fi tting and reducer securely.
15. Place thrust washer (item #47) over end
of drum shaft and slide downward until
spacer rests on drum. Press drum down-
ward to compress springs in gear hous-
ing.
Insert keys (item #32) into keyways with
sharp edge of keys pointing outward and
notched end of keys upward. A rubber or
brass mallet will be needed to gently tap
keys into position.
Apply grease to keys and end of shaft.
Place jaw clutch (item #5) over end of
shaft and slide jaw clutch over keys.
Set clutch housing (item #12) over end of
drum shaft. Pull jaw clutch (item #5) up-
ward, to ward clutch housing, enough to
allow yoke, in clutch housing, to fi t prop-
erly in groove around jaw clutch.