Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT User Manual

Page 5

Adhering to the following maintenance schedule will keep your winch in top condition and
performing as it should with a minimum of repair.

A. WEEKLY

1. Check the oil level and maintain it to the oil level plug. If oil is leaking out, determine

location and repair.

2. Check the pressure relief plug in top of the gear housing. Be sure that it is in good operat-

ing condition so that hot oil gasses may escape.

3. Lubricate cable with light oil.

B. MONTHLY

1. Lubricate the various grease fi ttings located in the cable drum, end bearing, clutch hous-

ing or clutch operating linkage. Any good grade of moly-disulfi de containing grease is

acceptable.

2. Check the action of the sliding clutch, making sure it is fully engaging and disengaging

with the cable drum. Remove the plastic plug in top of the housing and observe if the

clutch is fully engaging. If clutch is not fully engaging, inspect clutch shifter assembly

parts, check for damage or excessive wear and replace as necessary. Observe the jaws

on both the clutch and cable drum, checking for rounding of the driving faces. If rounding

has occurred they should be replaced immediately.

3. Check the winch mounting bolts. If any are missing, replace them and securely tighten

any that are loose. Make sure to use only grade 5 bolts or better.

4. Inspect the cable. If the cable has become frayed with broken strands, replace
immediately.

C. ANNUALLY

1. Drain the oil from the winch annually or more often if winch is used frequently.

2. Fill the winch to the oil level plug with clean kerosene. Run the winch a few minutes with

no load in the reel in direction. Drain the kerosene from the winch.

Refi ll the winch to the oil level plug with all purpose E.P. 140 gear oil.

4. Inspect frame and surrounding structure for cracks or deformation.

5. Gear wear can be estimated by rocking the drum back and forth and if necessary drain oil

and remove cover for closer inspection.

WINCH MAINTENANCE