Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT - Manual (Page 11)

9
14. Place winch with gear housing cover
down on work bench. Drum shaft
should be in vertical position. Slide
thrust washer (item #46) over drum
shaft and slide downward until washer
rests on gear housing. Set springs
(item #44) into pockets of gear hous-
ing with drag brakes (item #29) on top
of springs. Slide drum assembly (item
#8) onto drum shaft with drum jaws
upward.
13. Press bearing (item #16) onto worm and
into housing. NOTE: Be sure that thick
shoulder of bearings outer race (side with
manufacturer’s name and part number) is
out, away from worm threads. Place
gasket (item #30) onto adapter (item #2).
Attach adapter to gear housing using
four (4) capscrews (item #23).
TIGHTEN CAPSCREWS TO 12 FT. LBS.
(16.3 Nm.) EACH.
Insert keys (item #13) into keyways of
worm shaft. Slide tapered end of cou-
pling (item #6) over end of worm shaft.
Be sure roll pin (item #39) is in coupling.
Place motor shaft, with key in keyway,
into coupling. Secure motor to adapt-
er, using two (2) capscrews (item #24)
and lockwashers (item #28).
TIGHTEN CAPSCREWS TO 75 FT.
LBS. (102 Nm.) EACH.