Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT - Manual (Page 8)

6
2. Remove clutch housing (item # 12) and clutch
(item #5) from winch assembly.
Remove two keys (item #32) from keyways. A
screwdriver can be used, at notch, to aid in the
removal of key. Once keys have been removed,
drum (item #8) and thrust washer (item #47) can
be removed from drum shaft.
3. Remove motor (item #36) and coupling (item
#6) from adapter (item #2) by unscrewing two
capscrews (item #24) with lockwasher (item
#28).
Remove keys (item #13) from worm shaft. Un-
screw four capscrews (item #23) and remove
adapter (item #2) from gear housing. Replace
adapter seal (item #42) and gasket (item #30).
4. See page 12 for servicing the oil cooled brake.
Remove brake housing mounting screws (item #22)
and remove brake with gasket. Replace gasket
(item #30). Remove worm (item #15) and bear-
ings (item #16) from gear housing. Use soft ham-
mer to gently tap input end of worm and drive worm
and bearing from gear housing. Once worm has
been removed from housing, bearing can be
pressed from end of worm.
Check for signs of wear or damage to worm (item
#15) and bearing(item #16). Replace if necessary.
1. Drain oil from gear housing by removing plug
(item #38) from bottom of gear housing. Remove
plugs (items #35 & # 37) from top of gear hous-
ing. Remove handle (item #10) by driving pin
(item #39) from shifter shaft of winch. Remove
angles (items #3 & #4) from winch by removing
hardware shown.
INSTRUCTIONS FOR OVERHAUL
HSW10,000 DIS-ASSEMBLY