Ramsey Winch HSW-10000 RAM-LOK LOW MOUNT - Manual (Page 7)

5
CONDITION POSSIBLE CAUSE CORRECTION
Clutch inoperative 1. Dry or rusted shaft. 1. Clean and lubricate.
or binds up. 2. Bent yoke or linkage. 2. Replace yoke or shaft
assembly
3. Clutch jaws are in contact. 3. See Techniques of Operation
Oil leaks from 1. Seal damaged or worn. 1. Replace seal.
housing 2. Too much oil. 2. Drain excess oil. Refer to
Techniques of Operation.
3. Damaged gasket. 3. Replace gasket.
Winch runs too slow 1. Hydraulic motor worn out. 1 . Replace motor.
2. Low flow rate. 2. Check flow rate. Refer to
Hydraulic Systems flow
chart, page 4.
Cable Birdnests when 1. Drag brake disc worn. 1. Replace discs.
clutch is disengaged.
Hydraulic fluid leaks 1. Hydraulic motor shaft seal 1. Replace seal.
out hole in motor damaged.
adapter.
TROUBLE SHOOTING GUIDE