Ramsey Winch DC-200 SERIES LEVER - Manual (Page 3)

1
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most effi cient operation from your Ramsey Winch,
and safety procedures one needs to know before operating a Ramsey Winch.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifi cations. Great care and skill go into every
winch we make. If the need should arise. warranty procedure is outlined on the back of your self-ad-
dressed postage paid warranty card. Please read and fi ll out the enclosed warranty card and send it
to Ramsey Winch Company. If you have any problems with your winch, please follow instructions for
prompt service on all warranty claims. Refer to back page for limited warranty.
RAMSEY ELECTRICAL WINCH MODEL DC-200 SERIES
6
180
5
4
3
2
1
0
270 360
MINUTES
AMPS
90 120 160 190
1
2
3
4
5
0
MINUTES
AMPS
Winch duty cycles are shown below:
12 V 24 V
*These specifi cations are based on recommended 3/8 inch dia. extra improved
plow steel wire rope or equivalent.
Winch only conforms to SAE J706. For SAE qualifi cation of mounting angles,
if applicable, consult Ramsey Engineering.
Rated Line Pull 1st Layer (lbs.) .......................................................................................................... 8,000
(kgs.) .......................................................................................................... 3,630
Total Gear Reduc Ɵon: DC-200........................................................................................................... .... 470
DC-246.............................................................................................................. 360
Weight: DC-200/0C-246 (long drum)............................................................................... 116 lb. (52.6 Kgs.)
DCY-200/DCY-246 (short drum) ........................................................................ 105 lb. (47.6 Kgs.)
MAXIMUM GEAR BOX OIL TEMPERATURE SHOULD NOT EXCEED.......................................................... 250°F
Layer of Cable
Rated Line Pull
Lbs.
per layer Kgs.
Long Drum Cable Ft.
capacity per layer M.
Short "Y" Drum
cable capacity
Ft.
per layer M.
NO LOAD 2000# LOAD 4000# LOAD 8000# LOAD
Line Speed FPM FPM FPM FPM
VOLTS (MPM) AMPS (MPM) AMPS (MPM) AMPS (MPM) AMPS
DC-200/DCY-200 12 14 65 7 110 5 180 3.5 280
DC-24-200/DCY-24-200 24 (4.3) . 30 (2.1) . 50 (1.5) . 90 (1.1) . 140
DC-246/DCY-246 12 16.5 70 8.5 140 5.5 200 3.5 330
DC-24-246/DCY-24/246 24 (5) 35 (2.5) . 70 (1.7) 100 (1.1) . 160
1 2 3 4
8,000 5,700
25
7
15
4
6,700
3,030
60
18
30
9
3,620
90
28
55
16
5,000
2,260
140
42
75
22
2,580
SPECIFICATIONS: Conforms to SAE J706
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
DUTY CYCLE