Ramsey Winch DC-200 SERIES LEVER - Manual (Page 14)

12
7. Check for signs of wear on gear teeth. If
replacement of gear is necessary, replace as
follows:
a) Press gear (item #13) from shaft
(item #24).
b) Examine shaft keys and keyways. If
distortion of keys and/or keyways is
evident, shaft and keys should be
replaced.
c) Use a soft hammer to gently tap keys
(item #54) into keyways. Press gear
(item #13) over shaft and keys. Gear
must be centered over keys.
8. Remove seal (item #67) from back of gear
housing (item #16). Check bushing (item
#31) for signs of wear. Press bushing
(item #31) from gear housing and replace
if necessary. Press new bushing and seal
back into place.
10. Check clutch housing bushing (item #30)
for signs of wear. If necessary, remove old
bushings and press new bushings into
place. Apply grease to lube fi ttings (item #
55) to lubricate clutch shifter shaft.
9. Check drum bushings (item #30) for signs of
wear. Replace if necessary by pressing old
bushings from drum and pressing new ones
into place.