Ramsey Winch DC-200 SERIES LEVER - Manual (Page 17)

15
17. Press bearing (item #29) onto worm (item #25).
NOTE: Be sure thick shoulder of bearings
outer race (side with manufacturer's name and
number) is out, away from worm threads. Press
bearing and worm into gear housing. Slip
gasket (item #49) onto bearing cap (item #5).
Use four capscrews (item #33) to secure cap to
gear housing. Torque capscrews to 7 ft-lbs. (9.4
Nm) each. Attach solenoid assembly (item #1)
to gear housing. Use two (item #38) capscrews
and three (item #46) capscrews with three
fl atwashers (item #34). Tighten capscrews to 7
ft-lbs. (9.4 Nm) each. Insert plug (item #62) into
tapped hole of cover. Permatex may be applied
to threads to help prevent oil leakage.
TIGHTEN plug securely.
18. Press bearing (item #29) onto worm and
into worm gear housing. NOTE: Be
sure thick shoulder of bearings outer
race (side with manufacturer's name and
number) is out, away from worm
threads. Place gasket (item #49) onto
spur gear housing (item #15). Secure
spur gear housing to worm gear
housing using four capscrews (item
#37). Torque capscrews to 7 ft-lbs. (9.4
Nm) each.
Mount motor (item #57) to spur gear
housing (item #15) using three
lockwashers and nuts (items #47 & #45).
Attach solenoid cables to motor
terminals. Tighten all nuts securely.